FSiPanel forums

Hi JP,

yes, the trim was the main problem, because after setting up "Enignes Running", the trim was set to UP/13.5 (Maximum). I only can change this, when I disconnect my controller as you show me in the video. After connecting, trim can't be increased or decreased. But I also can't find a Key ...

Have you tried turning controllers OFF as shown on my video?


Hi JP,

hm.... ;-) No... I havn't .... but now I deactivate it ... and it works... (I tried it a several of times).

Also I start (with enabled Controller) with the Aerosoft A333 - same issue. If I deactive the controller, it works ...

My Video: https://youtu.be/KDsU_hQ7r8A

I used a fully configured FSLabs. Initialization was done, Enginges are running. After moving the Aircraft "in the air", the problem starts... I can't take control, because the Aircraft is instabile... so I can't do any training... before the MCDU is set, the ...

HI JP,

after trying a couple of times ... it doesn't work.

I have full control to the Thrust, because I see that in the E/WD-Monitor. If I go forward, also the N1-Level increase, if I go backward, N1 decrease. Also on the Sick: I can control to the left AND to the right, but I can't control ...

Hi J-P,

thank you very much for your video. I'll compare it today; if this doesn't work, I'll create my own video to show you, whats wrong (or: what I do wrong).

Best regards & thanks for supporting me.
Thomas

Hm...

I deleted all Axis-Assignment in the FSUIPC... start FSiPanel again... it is stabilized ...BUT .. it is frozen on the same position. I have groundspeed 250.. but the aircraft is sinking. No chance... Thrustlever on Maximum ... it's frozen (but: GS 250!!).

Sorry, don't know to fix this ...

Hi JP,

thanks for your reply. I think,I am using the FSLab-Key Assigments (over P3D). I'll try to disable FSUIPC Key/Axis-Assignments next time (in my opinion, I have no assignments, but I'll check this later).

But, when I understood you correctly, when disabling my Sidestick, how can I fly ...

Hi Guys,

I use the Thrustmaster Stick & Quadrant and have problems with using the application. I prepare my flight as described in the video tutorial for the a320. That means: Waiting for the initialization messages, Enginge are running, standing on the runway (e.g. EDDN, 10). Setting up my TCA for ...