FSiPanel forums

J-P

The problem has returned. I did an approach into LPMA and the landing report worked fine. Then made a further approach into PGUA, and when I had completed the landing - the landing report would not open.

I was flying the PMDG 737-800 on both occasions.

The only thing that I thought might give you a clue as to why this is happening, is that after the first landing at LPMA - I did use the FSiPanel 'after landing' workflow. That said, I have closed FSiPanel and MSFS 2020 and relaunched them, and the problem persists - so whatever is happening - it is locking the ability for me to open the landing reports. I can no doubt get it working again by reinstalling FSiPanel, as I did last time, but thought I should share this further occurrence.

ok thanks, a new landing report is on the way...
I guess you might be closing FSiPanel with the landing report open ?

regards,

J-P

J-P

How goes it? I was concerned that I was doing something wrong, but realized that I am not the only one with the Landing Report issue. It was easily accessible in the past but over the last few months it seems to not longer be available.

Could it be that there is something from preventing it from loading or being accessible? The Landing Reports page is Blank.

.NET Framework installed:
v4
Client 4.8.09032
Full 4.8.09032
v4.0
Client 4.0.0.0
.NET Framework Version: 4.8 Or later


Simconnect Versions installed
SimConnect Client v10.0.61259.0

FSUIPC
7.321


Kroswynd
MJC Support Team

Hi,

Thanks for your message, we only had the issue with one pilot.
Now 2 with you, do you have latest version 1.0.0.67 ?

The window opens but no graph ?

Regards,

J-P

Hi J-P,

That is correct, the window opens but no graph. I am using the latest version 1.0.0.67