Since Update not working

[DS2508]

Hi,

i made the update but since then the programming of the FMS is no more working. The Systems inserts the fuel figures in the scenarios but no more FMS feeding like Speeds or routing or SID etc. Any help for that?

Install new?

Thanks!

[DS2508]

is there any support emailadress?

[jpgarraio]

Hi,

Which Simulator, which airplane ?
Any hardware MCDU installed ?

Regards,

J-P

[Hiflyer109]

Hi JP

Same problem. Saving snapshots or training scenarios don't program the MCDU.
Running MFS2020 Fenix A320 with Winwing MCDU. Tried programming on the FO side MCDU and CPT side but once I save the snapshot it doesn't load correctly and the programming is all mixed up. Any solutions?

Thank you

[jpgarraio]

Hi,

I'm working on it, you should always use CAPT MCDU when recording a snapshot.
If you have winWing MCDU, make sure to select it in SETUP / FENIX, FSiPanel will then use FO MCDU to input data while you can use your winWing on CAPT side.

I will push an update probably tomorrow to fix the MCDU setup on scenarios.

Cheers,

J-P