Not sure how to title this? - one for J-P
Posted: Sun Oct 30, 2022 1:45 pm
I use a Thrustmaster Hotas throttle and separate joystick. I bind both the throttle and joystick using FSUIPC.
Now here is the issue. When I am using the Fenix A320, I position the plane on the runway of my selected airport which was EGPH, opened FSiPanel and choose my positioning for landing - in this case it was LH base. So, FSiPanel sets the aircraft up, and then I take control.
The first time I choose to increase the flap (using the flap button on the Hotas throttle unit) - it does not work - but it does on all subsequent requests to increase the flap position - it is just the first attempt.
The same applies to the landing gear - press it on the Throttle unit - nothing happens first time - second time I press it - works fine.
If, I am not connected to FsiPanel - then both buttons work first time in the Fenix A320 - so I can only assume that something within the FSiPanel setup is causing this?
Any thoughts?
Now here is the issue. When I am using the Fenix A320, I position the plane on the runway of my selected airport which was EGPH, opened FSiPanel and choose my positioning for landing - in this case it was LH base. So, FSiPanel sets the aircraft up, and then I take control.
The first time I choose to increase the flap (using the flap button on the Hotas throttle unit) - it does not work - but it does on all subsequent requests to increase the flap position - it is just the first attempt.
The same applies to the landing gear - press it on the Throttle unit - nothing happens first time - second time I press it - works fine.
If, I am not connected to FsiPanel - then both buttons work first time in the Fenix A320 - so I can only assume that something within the FSiPanel setup is causing this?
Any thoughts?