FSiPanel forums

I have just had a couple of flight approaches with FsiPanel and the PMDG 737-800.

First approach was into EGYP with the RH base starting position - all was fine. Now with the 737-800 sitting on the taxiway at EGYP, I setup a similar approach into BIKF the only difference this time being that I started from the LH base position.

When the approach was configured, I noticed two differences from the first approach into EGYP.

1) the gear was in the 'down' position
2) the distance rings on the map display were not showing

Whilst I appreciate that both of these can be easily rectified, I thought I would mention it, in case something is missing from the FsiPanel workflow.

Cheers

Hi,

I have to give it a try to see if i can reproduce that.
So first landing no issue, you vacated the runway and then started from here the second approach right?

J-P

J-P

That is correct, I vacated the runway and then started the second approach from there.