FSiPanel forums

Hello,

once in the air after ‘Move AC’, I never get the notification, that it is ok to take over. Consequently I am never sure whether I am interfering with any FSi panel processes.
How can this be fixed? Because I am running just into too many failed setups, plane drifting and pointing 45°away from the airport, AC suddenly trying to climb extensively and what have you. My ears are still ringing from all the alarms kicking off!

Hadn’t tried in a long time, today maybe 1.5 approaches out of 4 (in the case of the 0.5 I had to cancel the autopilot early on and hand fly the the A310 like it was a Cessna).

So, sorting out the missing notification window, might be a start to fix things for me.

Dirk

Hi Dirk,

Notification window is probably minimized.
Please go to SETUP / Options and click on Reset Initial Position.
Then move the window where you want it to be displayed, after 30s, your choice will be saved.

Cheers,

J-P

That fixed it, I was not even aware that this could be reset, thank you, JP,

Dirk