FSiPanel forums

Hi J-P.,

Just updated my FSiPanel to the new V1 CUT.

The update went very smoothly and after rebooting my computer and sim did a light scenario.
Got a Fac2 failure after take-off and got sent by ATC to hold and prepare for return landing which
I managed under difficult conditions with rain and wind @ 258/12 and managed a good landing report, thanks to all the training I had
previously done on FSipanel. Thank you again for this fantastic training tool.

Please keep the videos and scenarios coming,

Cheerio,
Mike

Hi Mike,

Thanks for your feedback, well done!
Not an easy failure to handle as single pilot.
I did not get this one yet, I have mode Hydraulic and Engine failures

Cheers,

J-P