FSiPanel forums

Hi,

following every advice in the tutorial, I nevertheless always get repeating messages from atc,

-> regardless if I try voice or voice + text.

Cockpit setup is ok, Weather loaded, all seems fine.

Then
- Calling clearance delivery works,
- reading back clearance works,
but then it keeps „repeating to call apron when ready for push and start “, regardless if I stay in the 30sec read back window with my answer or not.
I acknowledged with the ptt (which in itself is working because the system acknowledges my initial readback)

Special Info:
I upgraded from standard to advanced edition, does that matter?


please help:-)

cheers,

Specs
i7-13700
64GB RAM
GeForce RTX4090
3 32“ curved screens
MSFS2020 PC version
Fenix A320
Spad.NEXt
A320 yoke and throttle unit, 2FIP
Saitek Yoke and pedals
Honeycomb Bravo

continued:

just trying scenario LSGG-LSZH
with text
only
and with voice and text.

no voices to hear (…I did the Audio test which worked) but just messages and the messages keep repeating, even if I acknowledge with PTT and click the acknowledge button (in the text field)

the atc instructions do, however, follow the flight (climb, descend, intercept and so on), so the logic seems to work.

I am confused;-)

Hi,

I will give it a go this morning LH350, which aircraft do you fly?

Cheers,

J-P

The A320 Fenix

and thank you very much in advance !!
I am looking so much forward trying these scenarios with ATC.

I am familiar with ATC usage as I am flying online on VATSIM.

I just tried it without any issue except the routing which has probably changed with the AIRAC, will need to update it.

I suspect that you're using the say again button maybe? Can you check your buttons settings for PTT and Say Again.

Next release will have a radio noise when readback is correct using Voice only

J-P

Hi, I might have found the issue, I'm running some tests.
Could you please contact me at support at fsipanel.com,

I will send you a version to test.

Cheers,

J-P