FSiPanel forums

A little help please!
On my first training scenario SWA 330 Kpsp-> Klas
Flying the MSFS default 787-10
I cannot hear ATIS on 123.45. Everything else using PTT getting clearance , ground comm etc ALL work "LOUD and Clear".
What am i doing incorrectly?
best regards

Hi, confirm on COM2 ?

Cheers,

J-P

Hello JP,
thanks for the reply BUT
on the default 787-10, I tried 123.45 on ALL 3 radio panels, "L" (COM 1), "C"( which is normally used for DATALINK) and "R"(COM 2). NO reception or ATIS on any of them.
Can you please try the default 787-10 and let me know if you have success?
thanks

PS: When I fly the default MSFS202o Longitude and I tune COM2 to 123.45, I can hear ATIS "5/5, Loud and clear". Its only in the 787-10 that i trouble

ah ok thanks, let me check

Hi,

No issue on my side, please check
https://youtu.be/OzQydrg7zlg

Cheers,

J-P

J-P
Thank you very much. THAT WORKED!! just like in your video

A follow up question please, When I PAUSE the sim ( Active pause) and come back to UNPAUSE/ reactivate the flight, I lose the FSI ATC communications going forward entirely. Is there something different that i should do to get the ATC going again?
Thanks in advance

Hi,

Sorry I don't know what you mean by losing the ATC window?

You mean no more messages are issued by FSiPanel ? no voices either ?

Regards,

J-P

J-P
that is correct. After sim PAUSE/ Unpause no more FSI ATC window , voice or text even after multiple attempts at " Say it Again"
hari

PS: I have watched your streaming youtube inauguration video ( TNCM-> TFFR) 3 time so far and LOVED and learned something from it EVERY MINUTE !!. Great Job !! Thank you .

Also as a small request for future videos, for some of us who do not have PMDG of FENIX, it would be great if you could do a challenging training scenario in an MSFS default generic aircraft ( 787-10 or Longitude). Thanks