FSiPanel forums

Hello,

first of all, many thanks for FSiPanel, a very useful program!

I've noticed an issue with Aerosoft CRJ and wasm gauge. When FSipanel is activated, the sim console is flooded with "invalid variable class" errors. These errors continue even after you go back to menu and select a different aircraft. After a few minutes of this, MSFS console overfills and the simulator begins to stutter. The only way to stop the errors it is to restart the simulator.

I'm not sure if this also happens when MSFS dev mode is off, but these errors are worth checking.

Hi,

Thanks for the information, I will check it out.

Cheers,

J-P

Hi Again,

Just tried couple of approaches with the CRJ900, no issues.

What are the steps you're doing exactly ? Airport, runway, position, CRJ550/700/900/1000 ?

I will try to reproduce.

Cheers,

J-P

Hi, sorry for the late response. I only have CRJ 700, here's an example config I use.

The stream of errors begins during FSiPanel flight preparation phase and continues until the sim is restarted. One thing I noticed, is that the errors are about ASCRJ_TO_REV1_MODE, but there is no such variable. The aircraft is using ASCRJ_TQ_REV1_MODE for the reverser arming switches. So it may be a simple typo somewhere.

Thanks ! i check that now and if a typo it will be corrected with tonight's release.

Cheers,

J-P

Done, you were right, many thanks !!!
Any other tips on the CRJ or something missing on the config?

Cheers,

J-P

Ok, fixed, thanks! Haven't noticed any more issues, all is good.