Page 1 of 1
MD11 1.07 Issue
Posted: Mon Jul 22, 2024 12:13 am
by cchiozza
Is there an issue with the 1.07 and FSIpanel not working with the TFDI MD11? It worked before now it sets the flaps and thats it? It does not start to program the FMC.
Re: MD11 1.07 Issue
Posted: Mon Jul 22, 2024 4:49 pm
by jpgarraio
Hi, just tried, no issues.
Do you have a hardware for the FLAPS?
Regards,
J-P
Re: MD11 1.07 Issue
Posted: Wed Jul 24, 2024 7:59 am
by some1
Works for me too, except for little glitch that FSipanel does not disengage parking brake, so the simulation starts immediately after setup phase is finished.
Re: MD11 1.07 Issue
Posted: Fri Jul 26, 2024 3:48 pm
by Norwenkel
some1 wrote: Wed Jul 24, 2024 7:59 am
Works for me too, except for little glitch that FSipanel does not disengage parking brake, so the simulation starts immediately after setup phase is finished.
Same behaviour on my system. Seems to be an issue with the brake or parking parking bindings.
Re: MD11 1.07 Issue
Posted: Fri Jul 26, 2024 6:28 pm
by jpgarraio
Did you release the parking brake as indicated?
FSiPanel will wait until PB is released to move the aircraft.
Regards,
J-P
Re: MD11 1.07 Issue
Posted: Sat Jul 27, 2024 9:46 am
by Norwenkel
jpgarraio wrote: Fri Jul 26, 2024 6:28 pm
Did you release the parking brake as indicated?
FSiPanel will wait until PB is released to move the aircraft.
Bingo, the parking brakes has to be release before moving the aircraft to it´s position in the air.
Thanks a lot