FSiPanel forums

I have gotten to use the application twice before problems arose and not sure where to pinpoint it. Using the Fenix A320 at KCLT.

First - How long should it take to set up the Fenix A320 for a short final approach? It seems to take 5-10 minutes on the ground, then another 5 minutes in the air before asking to press the brakes.

Sometimes, when in the air during setup of the approach, it continues looping, but keeps getting closer to the ground until the plane collides with the ground. I then try to start the whole process over and restart for another 10-15 minute setup for it to do the same thing again.

Any ideas?

Hi,

It should take less than a minute.
If you wait 5 minutes on ground, your thrust levers are not exactly on CLB detend and FSiPanel is waiting for the timeout.
Please check that both your thrust levers are exactly on CLB or try with F3 key until you're perfectly set, once this is done, setup will start immediately.

Regards,

J-P