Page 1 of 1

Can't Start RJ100 in Take-off Mode on Runway

Posted: Tue Jan 21, 2025 3:12 pm
by GlenC
I have just obtained a MS2024 licence for FSiPanel to practice Approaches in the Just Flight RJ100.

Problem is I cannot load the RJ100 in a Take-off state on a Runway in either MS2020 or 2024, I appreciate this is not the fault of FSiPanel, I have submitted a query on the Just Flight forums.

Just wondering if any of your Beta Testers had this problem ?

On the couple of occasions I did get the RJ up to Take-off State manually and tried a DOWNWIND Position, FSiPanel started to do its thing, but prior to getting to the 'Hold Brakes for 3 secs' state the aircraft started Spiralling to the ground.

Glen

Re: Can't Start RJ100 in Take-off Mode on Runway

Posted: Tue Jan 28, 2025 8:58 pm
by jpgarraio
Hi,

I did not get any issue with the RJ, if you start on a runway, are your engines off ?
Regards,

J-P

Re: Can't Start RJ100 in Take-off Mode on Runway

Posted: Sat Feb 01, 2025 12:13 pm
by GlenC
Sorry I should have edited my original post.

I heard from Just Flight regarding the RJ and there appears to be a Saved State not working correctly.

From Just Flight support : In the meantime, pressing the "Ready To Fly" button as soon as it becomes available during the pre-flight cinematic should allow the aircraft's save state to initialise correctly.

This does indeed seem to work :)