FSiPanel forums

Hi!

I got issues with the Headwind A330 (latest Update 0.7.0). When I start with "Move AC" it takes a unusual longer time to even get me to the point where I should set the thrust levers to CL detent. After another longer than usual amount of time the approach set up starts but the plane starts to either move to the left or up, nothing more seems to happen (or at least I gave up after 2 or 3 minutes). Fenix A3xx and PMDG 737/777 work without any problems. I tried different airports (tbh always only short approach). Are there any logs i could provide?

Kind regards
Felix

Hi,

The only reason I see why it takes time is because of your FLAP not moving into position.
Can you check engines are running, hydraulic is pressurized.
Do you see the flaps moving?

Regards,

J-P

Hi J-P!

So heres what happened:
I started MSFS2020 and tried on LOWW 16, FSiPanel Short Final to see if the flaps were moving - they did. Plane was taken into the air but then showed the same behaviour as described in my original post. So i decided to take a video and left to the main menu to start over again. Went back to LOWW 16, then started FSiPanel on Short Final, started video recording and when the plane was in the air it suddenly seemed to work normal. Waiting for telling me to turn off the beacon light, suddenly FSiPanel crashed. I restarted FSiPanel in mid air and chose LOWW 16, Short Final again. This time eveything worked fine. After landing i took another round and it kept working. I don't know what fixed it, as i had this issue before multiple times prior to my original post (in different MSFS2020 sessions, restarting the sim and even the computer and also on different airports).

Hope it stays like this

Kind regards
Felix