FSiPanel forums

any a320, ms2024, when attempting e.g Fix- Long Final during and after set up a/c goes into overspeed, no.1 eng remains at idle whereas no.2 eng is at t/o. after Appr set there is no nav capture, sometimes loc capture ok. Hits runway at about 180kts with the one engine... I have tried so many times, re-booted MS2024 , re-booted pc, tried different A320's, Fenix, Inibuilds etc...all very frustrating

When back in Ms 2020 and fsipanel 2020 everything works fine!

Any ideas

Hi,

looks like a calibration issue, are both of your thrust levers in CL detent ?
Can you provide a screenshot ?

Regards,

J-P

For sure an issue on your side as it happens with all aircraft.
If you set your Thrust levers to CL detent, you should see both engines N1 increasing.

I am sorry J-P!

I did need to re-calibrate throttles settings for different a320's..
Thanks