Fenix - Position doesn't work after go around

[srcejon]

Hi,

I'm using the Fenix A320 - I would like to re-position for another attempt at an approach after going around, but this doesn't seem to work. Should it?

(After pressing Move AC when aircraft is in go around phase, the aircraft moves, but altitude/airspeed results in aircraft nearly crashing before I'm able to take control, and the MCDU isn't setup as would be the case if pressing Move AC on the runway).

Thanks.

[jpgarraio]

Hi,

Just fly the Go-Around until you're out of GA modes.
Then if you want to reposition to FINAL, make sure the aircraft IAS is compatible with Flaps FULL...

Configure the aircraft for the position you want to fly from, for FINAL, reduce speed and set flaps 3 or FULL as desired, then launch the approach in FSiPanel.

Regards,

J-P