FSiPanel forums

Hi J. P.,

Since I use my Winwing FCU for Fenix, I keep getting the message 'error/please turn off Scrolling Acceleration in the EFB' when my aircraft is ready, even though that setting is actually off (see screenshot). I can only correctly use FSIPanel then by quickly manually switching this setting back and off again for 4-5 times before it is recognized as 'off', and quickly setting some minimum altitude manually in the FCU otherwise the Fenix sinks to the ground during preps.

This workaround does work, but it is a bit tedious to repeat it for every time when opening FSIPanel. Is the problem on my side, or is a fix possible so that at least the Scrolling Acceleration in Off position is recognized?

Regards,
Lennard

Hi,

I do not have this FCU, difficult for me to replicate.

FSiPanel is working with the standard MSFS setup, any hardware can then interfere and cause issues.

I will have to look at it with some more documentation.

Cheers,

J-P