Page 1 of 1
Fsi cannot locate the community folder, please paste the community fold path
Posted: Sun Jun 02, 2024 8:37 am
by wdm12
I recently updated the FSI panel and every time I run it, a message shows up " Fsi cannot locate the community folder, please paste the community fold path." I pasted the correct path and made an input of the path, but it still shows up every time I run it. please advise what to do. Thank you! Please refer to the picture I uploaded.
Re: Fsi cannot locate the community folder, please paste the community fold path
Posted: Mon Jun 03, 2024 3:09 pm
by jpgarraio
Hi,
did you install FSiPanel with a different username than MSFS?
Could you try to delete config.xml and start over to see if the directory is found ?
If not, please contact me at support at fsipanel.com
Regards,
J-P
Re: Fsi cannot locate the community folder, please paste the community fold path
Posted: Tue Jun 04, 2024 1:38 am
by wdm12
Thanks J- P
I will give a try and feedback ASAP.
Re: Fsi cannot locate the community folder, please paste the community fold path
Posted: Fri Jun 07, 2024 1:04 pm
by wdm12
Hi J-P
I cannot find Config.xml under Fsipanel folder, which config.xml do you want to delete? can you give me a bit details please? Thanks.
Re: Fsi cannot locate the community folder, please paste the community fold path
Posted: Fri Jun 07, 2024 1:38 pm
by wdm12
HI J-P
I found the config.xml under C drive and deleted it, restarted the FSI panel, chose KG and meters in the pop up menu, then it required community folder path, pasted it and closed FSI panel , restarted it again, unfortunately, it requires community folder again. Deleting the config.xml does not seem to solve the problem. Any advice? Thanks
Re: Fsi cannot locate the community folder, please paste the community fold path
Posted: Sat Jun 08, 2024 4:00 am
by wdm12
jpgarraio wrote: Mon Jun 03, 2024 3:09 pm
Hi,
did you install FSiPanel with a different username than MSFS?
Could you try to delete config.xml and start over to see if the directory is found ?
If not, please contact me at support at fsipanel.com
Regards,
J-P
Hi J-P
Now I found this community folder path issue is rather interesting. I tried Fenix 320 a few times, it works all fine, no pop up message asking to paste the community folder path at all. However when I switch back PMDG 737 600 (Microsoft marketplace version) the message always pops up asking for community folder directory. I just did the update today and for PMDG 737 600, the message still shows up every time when I run Fsipanel. Any ideas?
Frank
Re: Fsi cannot locate the community folder, please paste the community fold path
Posted: Sat Jun 08, 2024 9:41 am
by jpgarraio
Hi Frank,
Fenix does not need the community folder to work with FSiPanel, but PMDG does for the snapshots and SID/STARS.
Could you please contact me by email at support at fsipanel.com? We will conduct some troubleshooting.
We have encountered a case where a user installed MSFS on one user account of the system but installed FSiPanel on another. As a result, Windows created two independent folder structures on the system, causing accessibility issues.
Regards,
J-P